PDA

View Full Version : Tip in stumble


VIN7
06-28-2009, 02:02 AM
I was out logging and I have a tip in stumble. Example, driving with steady tps input, then you go wot. The car will stumble for a sec then clear out. I have tps enrich at .85 and map enrich at .6

You can see it at frame 896, look at the rpm trace you'll see the stumble there.

Any ideas?

Mike

TurboBob
06-28-2009, 03:34 AM
thats a ton of enrichment.

Try setting the TPS enrichment to .25, decay to .60

set MAP enrichment to .10 and boost enrichment to 0


See if that helps

Bob

turbott
06-30-2009, 03:24 AM
Instructions could use a "suggested range" for enrichment adjustments.
Is 10 ok ? or .1 too much ?

turbott
06-30-2009, 03:38 AM
Does your spark advance look funny ? 25* at idle , 22* at wot ?

Really loose convertor ? rpm hardly changes through 2nd & 3rd ?

VIN7
06-30-2009, 01:33 PM
Does your spark advance look funny ? 25* at idle , 22* at wot ?

Really loose convertor ? rpm hardly changes through 2nd & 3rd ?


Idle spark is what is programmed into the extender, and 22* is what I command in 3rd.

Its a whole new trans/conv setup. The gov is mismatched which is causing the low rpm shift. The conv is a 9/11 3000rpm stall. I think once I get the shift rpm up, the conv should couple more efficiently.

Mike