|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
| Home | Online Store | Product Manuals | Register | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
07-28-2010, 05:19 PM
|
||||
|
||||
roller rockers
Hi Mike, I am looking to buy a set of roller rockers and was wondering what ratio I should buy? I am looking to get the most out of my motor. My specs are in my signature.
Thanks
__________________
1987 GN 3" Huston down pipe, SS exhaust,Poston headers, .030 over 109,210/215 roller cam,hand ported heads, fuel pump,hot wire kit, adjustable reg.,60# injectors,power logger, scan master, TT chip, 6131 bb turbo, PTE SLIC, March pulleys, RJC power plate,70mm TB,4"MAF pipe, 3.5" LS1 MAF Sensor, MAF TRANSLATOR,4"K&N under drivers side front fender, Razer alky kit, fresh trans with 9.5" TC. 
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Linear Mode
