|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
| Home | Online Store | Product Manuals | Register | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
04-23-2010, 06:30 AM
|
|||
|
|||
Initial set up
other than selecting the size of my MAF 3" or 3.5 and my injector size is there any other type of initial setup like maybe selecting 1G, 2G or 3/S. The older version 1.3 had a 1G, 2G dip switch is this done in a different manner on 2.02
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Linear Mode
